TDM over IP
DS3/T3 over IP/Ethernet

VCL Products > TDM over IP > DS3/T3 over IP/Ethernet - Technical Specifications
DS3/T3 over IP/Ethernet - Front
DS3/T3 over IP/Ethernet
DS3/T3 over IP/Ethernet - Back
DS3/T3 over IP/Ethernet - Front
DS3/T3 over IP/Ethernet
DS3/T3 over IP/Ethernet - Back

Our Gigabit Ethernet (GE) version products use a High Stability Timing, Ultra Low Noise OCXO for accurate timing and highly stable clock synchronization. This provides very stable clock synchronization and exceptional performance even under the most demanding network conditions.

DS3/T3 over IP/Ethernet
TDM over IP / TDM over Packet / TDM over Ethernet
Technical Specification

Read More Data Sheet Comparison Chart

'VCL-DS3oP', DS3/T3 over IP / Ethernet equipment provides transmission of one, point-to-point, DS3/T3 link over an IP / Ethernet, MEF or MPLS Pseudo-wire networks. The DS3oP is compatible with AES/DES Encryption Data standards. The 'VCL-DS3oP', DS3/T3 over IP / Ethernet equipment is powered by a powerful PowerPC 400 MHz Processor which provides a highly reliable clock recovery mechanism for low jitter and wander control, even under variable network conditions.

Port Trunking and Spanning Tree Protocol

DS3oP Specifications

Max number of logical Link One point-to-point logical link
Max DS3 payload MTU Size User configurable from 1 to 1800 Bytes
Supported Transport Mechanisms IETF-PWE3 and SAToP
Supported PSN (Packet Switched Networks) type UDP, IP, MPLS and MEF
QoS 802.1q, 802.1p packet priority

Gigabit Optical Ethernet Specifications

Type SFP
Compliance
  • Compliant with IEEE 802.3z Fast Ethernet 1000BASE-LX
  • MSA Compliant
  • RoHS
  • EMI
  • ESD
  • DDM
Safety Class 1 Laser Safety/ IEC-60825 Compliant
Bit Rate 1.25 Gbps
Wavelength 1310 / 1550 nm
Distance 550m to 80Kms, as per order
Optical Connector LC

Command Language

  • Windows based GUI (Graphical User Interface)
  • Command Line Interface (English text commands)

Environment

Temperature -20°C ~ +60°C for Operation
Storage -40°C ~ +70°C for Storage
Humidity 5% to 95% (at 35°C) Non-condensing

Chassis

  • 1U High (44mm)
  • 19-inch rack-mounting shelf
  • Also available in Desktop / Table Top Version.

Regulatory Compliance

  • Safety - IEC 60950 Safety - IEC 60950
  • CE
  • RoHS
  • Complies to ANS/IEC standards
  • Complies with Telecom Part 68, FCC Part 15 and CISPR 22 Class A
  • EMC EN55022: 1998 + A1 and A2
  • EMC EN55024,
  • Operation ETS 300 019 Class 3.2
  • Storage ETS 300 019 Class 1.2
  • Transportation ETS 300 019 Class 2.3

NMS (with Telnet) OAM port Specifications

Network Interface RJ-45 10/100/1000BaseT (Auto sensing)
Compatibility Ethernet Version 2.0 IEEE 802.3
Protocols supported ARP, UDP/IP, TCP/IP, Telnet, ICMP, SNMP
Management SNMP, Serial login, Telnet login
EMI Compliance
  • Radiated and conducted emissions complies with Class B limits of EN55022:1998
  • Direct and Indirect ESD complies with EN55024: 1999
  • RF Electromagnetic Field Immunity complies with EN55024:1998
  • Electrical Fast Transient / Burst Immunity complies with EN55024:1998
  • Power Frequency Magnetic Field Immunity complies with EN55024:1998
  • RF Common Mode Conducted Susceptibility complies with EN55024:1998

External Alarms

  • Dry Contact Relay - 2 Form C
  • Rated upto 72V DC, 1 Amp.

Mechanical Specification

Height 44 mm (1U)
Depth 260 mm
Width 480 mm (19 inch rack mountable)
Weight 4 Kgs.

DS3 Interface

Number of Port One
Framing Formats Framed, Unframed (User selectable)
Framing B3ZS and G.832 framing modes (user selectable)
Line Coding Meets ANSI T1.404 M13 or C-bit parity
Line Impedance 75 Ohms

Gigabit Ethernet Optical Interface Specifications

Optical Interface Type SFP
Compliance
  • Compliant with 1000Base-LX
  • MSA Compliant
  • RoHS
  • EMI
  • ESD
  • DDM
Safety Class 1 Laser Safety/ IEC-60825 Compliant
Bit Rate 1.25 Gbps
Wavelength 1310 / 1550 nm
Distance 550m to 80Kms, as per order
Optical Connector LC

Gigabit Ethernet Switch Interface

Number of Ports 4 Ports - 2 Gigabit optical ports and 2 GigE (electrical) ports. Complies with IEEE802.3, 802.1Q and 802.1P
Electrical 10/100/1000 Auto-negotiation / MDI-X (Auto-sensing),
Full-Half Duplex, RJ45 Electrical Connector
Protection ESD protection
Maximum Frame Size 9000 Bytes (Jumbo Frames)
Switching Capacity Upto 6 Gbps, Non-blocking

Management and Control Interfaces

  • COM Port (RS232 Serial Port)
  • USB Port
  • 10/100/1000BaseT Ethernet Port (each multiplexer may be assigned an IP address and connected to a LAN / IP network for remote access and management through the 10/100BaseT Ethernet Port for in-band configuration, management and access)
  • Telnet
  • SNMP, V2 Monitoring
  • Additionally, a Windows based GUI (Graphical User Interface) for easy configuration, management and access.

Power Supply Options

  • Dual Redundant (AC + DC)
  • 1+1 AC power (100 to 240V AC, 50 / 60 Hz)
  • 1+1 DC (-48V) power (40 to 72V DC)
  • 1+1 DC (-24V) power (18 to 40V DC)
  • AC or DC

24V DC Power Supply Specifications

Power Supply 24V DC
Range of input 18V to 40V DC
Input voltage reversal protection Provided
Under voltage protection < 4.85V
Over voltage protection > 5.15V
Efficiency at full load > 90% @ 5V/4A (when input voltage-24V)
Ripple at full load < 5mVrms
Spike at full load < 50mV

Power Consumption

Power Consumption <18 Watts

48V DC Power Supply Specifications

Power supply -48V DC
Range of input -40V DC to -72V DC
Under voltage protection < 4.85V
Over voltage protection > 5.15V
Efficiency at full load > 91% @ 5V/2A (when input voltage -48V)
Ripple at full load < 5mVrms
Spike at full load < 50mV

AC Power Supply Specifications

Input AC Voltage 110 / 220 Volts AC
Range of input AC Voltage 100 V to 240 V AC, 50Hz/60Hz.
AC Input Connector IEC Connector
Application # 1: TDM over IP in Cellular/Mobile Backhaul (Integrating 2G/3G/LTE Networks)
Application # 2: TDM over IP 2G/3G/LTE - Typical Application in a redundant Wireless Network (1+1 Link Redundancy)
Application # 3: TDM over IP/Ethernet - Providing 2G/3G/LTE over an IP Cloud
Application # 4: TDM over IP with Fractional E1 (Supports CESoPSN and SAToP)
Application # 5: TDM over IP for 2G/3G/LTE in a redundant Wireless Network (1+1 Link Redundancy) with IEEE 1588 v2 Synchronous Ethernet
Application # 6: TDM over IP/Ethernet - Distributing E1s, ToD (Time-Of-Day) and Frequency Synchronization over an IP Cloud using IEEE 1588v2
Application # 7: TDM over IP/Ethernet: Using IEEE 1588 v2 to distribute E1s along with ToD (Time-Of-Day) and Frequency Synchronization over over Optical Fiber Ring
Application # 8: TDM over IP/Ethernet: Using IEEE 1588 v2 distribute E1s, ToD (Time-Of-Day) and Frequency Synchronization over a Complex Ring and Spoke Optical Fiber Networks
Application # 9: TDM over IP/Ethernet - Port Based Priority (Classifying Services)
Application # 10: TDM over IP/Ethernet VLAN Based Priority (Classifying Services)
Application # 11: TDM over IP/Ethernet Flow Control in an Ethernet Packet Network (Regulating Traffic)
Application # 12: TDM over IP/Ethernet Port / Customer based bandwidth allocation (Port Rate Limiting)
Application # 13: DS3 / T3 over an Ethernet / IP Networks
Application # 14: DS3 Link Redundancy - Using Port Trunking / Bonding
Application # 15: DS3 Link Redundancy - Using Spanning Tree Protocol
Application # 16: TDM over IP 2G/3G/LTE - Typical Application in a redundant Wireless Network (1+1 Link Redundancy)
Application # 17: E3 over IP / E3 over Ethernet with Link Redundancy using port Trunking / Bonding
Application # 18: E3 over Ethernet / Packet Link Redundancy - Using Spanning Tree Protocol
Application # 19: E3 Link over Optical Fiber / E3 OLTE
Application # 20: T1 over Packet Network with GPS Synchronization
Application # 21: T1 over Packet Network with PTP Grandmaster Synchronization
Application # 22: E1 over Packet Network with GPS Synchronization
Application # 23: E1 over Packet Network with PTP Grandmaster Synchronization
Application # 24: Point-to-multi-point E1 over Packet with PTP Grandmaster Synchronization
Application # 25: E1 over Ethernet, Point-to-multi-point links over separate carrier IP Networks
Application # 26: E1 over Ethernet, 1+1 Redundant Point-to-multi-point links over Separate carrier IP networks
Application # 27: Water Company (Madrid - Spain)
Application # 28: Electricity Company (Santander - Spain)
Application # 29: E1 transmission over secured encrypted links
Application # 30: Voice and data transmission over secured encrypted links
Application # 31: Encrypted “Mobile” Application for Voice and Data
Application # 32: Encrypted “Radio” Application for Voice and Data

Valiant Communications is an ISO 9001:2015, ISO 10001:2018, ISO 14001:2015, ISO 27001:2013 and ISO 45001:2018 certified equipment manufacturer.

Links

Home

About Us

Solutions

Applications

Data Sheets

Press

Project & Services

Reference Customers

Contact Us

Products

VCL IP/MPLS Routers

Teleprotection over E1, C37.94,
MPLS-TP, MPLS / IP, IEC-61850 GOOSE

IEEE C37.94 Solutions

VCL-PMU-30, Phasor Measurement Unit (PMU)

VCL-PDC, Phasor Data Concentrator (PDC)

Cyber Security Solutions

Router with Enhanced Security

Industrial Switches

Products

GPS / GNSS, Primary Reference Clocks (G.811)

GPS / GNSS NTP Time Server

PTP IEEE-1588v2 Grandmaster, PTP Slave, PTP Transparent Clock

NTP to IRIG-B, PTP to IRIG-B

GPS to IRIG-B, GPS to 1PPS Servers

Time Distribution, IRIG-B, 1PPS, RS-232 / RS-485

SDH with MPLS-TP & SONET Multiplexers

E1 PDH & Digital Cross Connect

Products

Optical Multiplexers

IP over TDM / Ethernet over TDM

TDM over IP / Ethernet / Packet / MPLS

E1 / T1, 1+1 Automatic Protection / Failover

1+1 Ethernet Failover / AB Fallback Switch

Groomer (Hi-Z Non-Intrusive Monitoring) - E1, T1 and STM-1

E1 and T1 Echo Cancellers & VQE

Serial to Ethernet and MODBUS Converters

Patch Panels, AC DC Converters, Passive Products